Storage And Maintenance; Disposal; What If There Are Problems - Beurer JBY 103 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30
10

storage and maintenance

The service life of the devices depends on careful use:
Important:
• Remove the battery if the device is not in use for an extended period.
• You will get the maximum capacity from your battery if you run down the
battery at least once every six months. To do this, disconnect the device
from the mains and run the battery down through normal use. Then fully
charge the battery up again.
• The maximum battery capacity can only be reached after it has been
charged several times and is dependent on many factors (battery state,
ambient temperature, means and frequency of charging, etc.).
• Protect the devices from knocks, damp, dust, chemicals, drastic changes
in temperature, electromagnetic fields and nearby sources of heat (ovens,
heaters).
• If dirty, wipe the device with a soft, dry cloth.
• Clean the device with a dry cloth. Do not use any abrasive cleaning
products.
11

Disposal

Batteries must not be disposed of with household waste. As a consumer, you
are required by law to recycle used batteries. You can recycle your old batte-
ries and rechargeable batteries at public collection points in your community,
or wherever batteries of the relevant type are sold.
note:
The codes below are printed on batteries containing
harmful substances:
Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury.
For environmental reasons, do not dispose of the devices including the batte-
ries in the household waste at the end of their service life. Dispose of the unit
at a suitable local collection or recycling point.
Observe the local regulations for material disposal.
Dispose of the device in accordance with EC Directive 2002/96/
Ec – wEEE (waste Electrical and Electronic Equipment).
If you have any questions, please contact the local authorities
responsible for waste disposal.
12

what if there are problems?

Faults
Actions
Monitor will not switch
Check whether
on.
• the mains part plug is properly plugged in,
• the battery is correctly connected,
• the rechargeable battery is full, needs charging
19
or is damaged.
Tabla de contenido
loading

Tabla de contenido