Beurer JBY 103 Manual De Instrucciones página 20

Faults Actions
On the monitor, Check whether
an acoustic signal • the maximum range has been exceeded,
sounds. • the mains part plug for the camera is correctly
connected,
• the camera is switched on.
• the battery needs to be charged.
The monitor is swit- • To set your desired volume on the monitor, press
ched on, but is not the right or left arrow buttons during operation.
making any noise.
The monitor switches • Recharge the battery of the monitor.
itself off. • It could be that the device is in energy saving
mode. Press any button to make the device exit
energy saving mode.
The signal is weak, • If another technical device such as a microwave
the connection keeps is in the area between the camera and the moni-
breaking up or there is tor, remove the device, or switch it off.
interference. • Check whether other factors, such as trees
or anything else are in the area between the
devices, and change the position of the devices
until the monitor signals a connection.
• Check whether the camera and monitor are
inside the maximum receiving range.
Faults Actions
If no transmission is Turn on both devices.
possible, you have the Open the menu bar by pressing the OK/Menu
option to retune the button. Select the „Settings" menu item and then
device signals digitally „Register". Select the required channel number (if
= pairing. you are running the video baby monitor with just one
camera, this is number 1). Press the OK/Menu but-
ton again. Keep the Connector button on the camera
pressed for approx. 3 seconds. After successfully
connecting with the camera, press the On/Off button
twice to switch to image transfer.
We hereby guarantee that this product complies with the European R&TTE
Directive 1999/5/EC.
Please contact the specified service address to obtain further information,
such as the CE Declaration of Conformity.
20