Tips And Recommendations; Questions About The Chronis Io; Technical Data - SOMFY Chronis io Manual Del Usuario

6) The screen displays "
7) The Chronis io returns to the previous step.
SAVE : NO
Choose " " and press OK to restart the procedure for setting the date and time parameters
from the beginning.
8) Press h or i until "
Àashes: press h or i until "
SET
9) "

8. TIPS AND RECOMMENDATIONS

Questions about the Chronis io?

Observations
The selected products do not
react at all when a button on
the Chronis io is pressed.
An end-product stops during
activation.
The order is shifted in relation
to the programmed time.
One or more end-products
systematically do not react
to a programmed automatic
order.
ERROR
" "
is displayed. The
Chronis io only works in
manual mode .

9. TECHNICAL DATA

Radio frequency: 868.95 MHz, io-homecontrol
Radio range: 20 m through 2 concrete walls
Protection rating: IP 20
Safety level: Category III
Operating temperature: 0 °C to + 60 °C (+ 32 °F to + 140 °F)
Dimensions (w x h x d): 120 x 80 x 21 mm
Power supply: 2 type AAA (LR03) 1.5 V alkaline batteries
Copyright © 2013 Somfy SAS. All rights reserved.
:
SAVE YES
". Click OK to terminate and save the settings for the current menu.
EXIT SET
" is displayed (after "
EXIT
" is displayed and press OK.
Possible causes
The batteries are low.
The remote control transmitter is
not programmed.
External radio equipment is
interfering with the radio reception.
The motor(s) or receiver(s) are in
thermal cut-out mode.
The end-product has encountered
an obstacle.
Another control point is sending an
order to the motor or receiver.
The Chronis io is in simulated
presence mode.
A signal from another automatic
device in your home is causing
interference.
Defect in automatic mode
and simulated presence mode
DEC
") and press OK.
Replace the batteries.
See section "Adding or deleting a Chronis io
at an end-product".
Turn off any radio appliances nearby.
Wait for the motor to cool down, then press
the desired button again.
Remove the obstacle and try again.
Wait until activation of the end-product has
¿QLVKHG WKHQ WU\ DJDLQ
Select automatic mode using the cursor.
Increase the number of frame repetitions.
See section ",QLWLDO FRQ¿JXUDWLRQ".
Change the programmed time for the
automatic order.
Contact an installer.
.
®
Chronis io
Solutions
13