Drive Settings; Network Management; Tips And Advice On Installation; Questions About The Product - SOMFY Zigbee Sonesse 28 WF Manual De Instrucciones

Sonesse 28 WF Zigbee
▪ Mobile phone or mobile device with operating system Android
The software version of the Set&Go Connect application may be updated from time to time to add new features and
services.

2.3.3.Drive settings

▪ Once the Set&Go Connect application is downloaded, open the app and
follow the instructions to set the drive.
▪ Once the drive is set, check the settings by pressing the button on the motor
head:
◦ To start the motorised product movement, briefly press the button on the
motor head.
◦ To stop the motorised product movement, briefly press the button on the
motor head.
◦ To move the motorised product in the opposite direction of the previous
movement, briefly press the button on the motor head again.
◦ To stop the motorised product movement, briefly press the button on the
motor head, and so on.

2.3.4.Network management

NOTICE
Network status when the motor wakes up: The motorised product briefly moves up and down. If the orange LED blinks, it
is not linked to any network. If the LED doesn't light up and the motorised product briefly moves up and down, then it is linked
to a network.
To join a network:
▪ Follow the instructions on the Set&Go Connect application,
▪ Press and hold the motor head programming button until the product moves
up and down twice.

2.4.Tips and advice on installation

2.4.1.Questions about the product?

Observations
The motorised product does not
operate.
©
Copyright 2021 SOMFY ACTIVITES SA. All rights reserved.
Possible causes
The control point battery is low.
Drive battery is low and requires charge.
Red LED blinks 3 times when any button
of a paired control point is pressed.
The control point is not compatible or
not programmed.
An obstacle hinders the movement of
the motorised product.
Drive position is out of the end limits.
Motor is not linked to a network.
The thermal protection has activated.
™
OS 6.0 and later.
Solutions
Check the battery and replace it as
required.
Plug in the external battery to the
charger.
Check the compatibility or replace the
remote control if necessary.
Remove the obstacle.
Proceed to section Drive settings
[} 5]
Proceed to section Network
management [} 5].
Wait for the drive to cool down.
EN
5