To Remove The Cutting Deck; Operation; To Fill Fuel; To Start To Use Husqvarna Connect - Husqvarna R 419TsX AWD Manual De Usuario

10. Push the lock handle down.
11. Set the lift lever for the cutting deck in the transport
position.
12. Move the weight transfer lever down to engage the
weight transfer.

To remove the cutting deck

WARNING: To prevent crush injuries, the
weight transfer function must be set to off
when you change accessories.
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.

To start to use Husqvarna Connect

1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Do the instruction steps in the Husqvarna Connect
app to connect and register the product.
880 - 006 - 09.09.2020
1. Do the steps 1–7 in
page 14 .
2. Pull and hold the lock handle.
3. Hold the front edge of the cutting deck and pull
forward while you hold the lock handle. Pull the
cutting deck to the end position.
Note: If you cannot pull the cutting deck to its end
position, release the lock handle and pull it up again.
4. Pull and hold the lock handle and lift the front of the
cutting deck until it releases. Lift until the front of the
cutting deck is released from the equipment frame.
5. Pull the cutting deck out.

Operation

To fill fuel

WARNING: Gasoline is very flammable. Be
careful and refuel outdoors, refer to
safety on page 13 .
WARNING: Do not use the fuel tank as a
support area.
CAUTION: Incorrect type of fuel can result in
engine damage.
To attach the cutting deck on
Fuel
15