Troubleshooting; Troubleshooting Schedule - Husqvarna R 419TsX AWD Manual De Usuario

2. Lubricate the 6 joints (A) with engine oil.
A
A
B
A

Troubleshooting schedule

If you cannot find a solution to your problems in this
operator's manual, speak to your Husqvarna service
agent.
Problem
The starter motor does not turn
the engine over
The engine does not start when
the starter motor turns the engine
over
The engine does not run smooth-
ly
The engine apparently has no
power
32
A
A
B
A

Troubleshooting

Cause
The parking brake is not applied. Refer to
brake on page 16 .
The drive of the blades is engaged. Refer to
page 4 .
A fuse is blown. Refer to
The ignition key is defective.
The connection between the cable and the battery is bad. Refer to
on page 13 .
The battery is too weak. Refer to
The starter motor is defective.
There is no fuel in the fuel tank. Refer to
The spark plug is defective.
The ignition cable is defective.
There is dirt in the carburetor or fuel line.
The spark plug is defective.
The carburetor is incorrectly set.
The air filter is clogged. Refer to
There is dirt in the carburetor or fuel line.
The air filter is clogged. Refer to
The spark plug is defective.
There is dirt in the carburetor or fuel line.
The throttle cable is incorrectly adjusted.
3. Lubricate with a grease gun through the nipple on
the pivot wheel bearings for the cutting deck (B).
Lubricate until grease comes out of the rear side of
the nipple.
To apply and release the parking
PTO (Power Take-Off) button on
To replace the fuses on page 24 .
To charge the battery on page 24 .
To fill fuel on page 15 .
To clean and replace the air filter on page 23 .
To clean and replace the air filter on page 23 .
Battery safety
880 - 006 - 09.09.2020