Replacing The Skirt; Replacing The Cutting Blade - Stihl FCS-KM Manual De Instrucciones

Replacing the Skirt

Removing the skirt
6
3
Undo and remove the screw (1).
N
Remove the washer (2)
N
Pull the skirt (3) out of the
N
segment (6) and out of the gap (5) in
the deflector
FCS
Fitting the skirt
5
6
4
1
2
In order to push the skirt easily into
N
the gap on the deflector, apply a thin
coating of resin-free oil to the top of
the skirt
Thread the skirt (3) into the
N
segment (6) and push into the
gap (5) of the deflector – the bore in
the skirt must be fixed in the
arbor (4)
Place washer (2) onto screw (1).
N
Insert and tighten the screw (1)
N
1 2
5
4
3

Replacing the Cutting Blade

1
A
B
C
Do not attempt to straighten or weld a
bent or cracked blade – it may break – it
must be replaced – see "Mounting the
Cutting Blade".
STIHL recommends you use only the
following original STIHL cutting blades:
Length Thick- Marking
ness
200 mm 2.4 mm 4133 / 01
200 mm 3.8 mm 4133 / 02
Do not resharpen the blade.
Replace the blade (1) if its
N
length (A) is no longer sufficient to
maintain the necessary ground
clearance (B) and obtain the
required depth of cut (C).
Checking Out-of-Balance
To avoid out-of-balance:
Have your dealer check the blade
N
for out-of-balance on a STIHL
balancer (special accessory) –
STIHL recommends an authorized
STIHL servicing dealer. If blade is
out-of-balance, fit a new one – see
"Mounting the Cutting Blade".
English
17