Mounting The Cutting Blade; Mounting The Loop Handle - Stihl FCS-KM Manual De Instrucciones

English

Mounting the Cutting Blade

Lay the power edger on its back so
N
that the blade mounting (1) faces
up.
5
6
4
2
3
Insert the stop pin (2) into the
N
hole (3) as far as stop – apply slight
pressure and turn back and forth
14
together with the thrust plate (4)
until the pin slips into position and
blocks the shaft.
Fit the combination wrench (5) on
N
the screw (6).
Loosen the screw clockwise (left-
N
hand thread) and take it out.
6
9
4
9
11
Remove the thrust washer (4).
N
Position the blade (9) on the thrust
N
plate (10).
WARNING
Collar (see arrow) must engage the
blade's mounting hole.
Fit the thrust washer on the
N
shaft (11) and block the shaft.
Fit the screw (6) in the shaft
N
counterclockwise and tighten it
down firmly.

Mounting the Loop Handle

Position of Loop Handle
2
4
10
A loop handle (1) may already be
mounted to the basic power tool.
Secure the loop handle (1) at
N
distance A = about 20 cm (8 in) in
front of the control handle (2) – if the
sleeve (3) and carrying ring (4) are
already fitted, they must be between
the loop handle and control handle.
A
1
3
FCS