Tabla de contenido
Idiomas disponibles
Idiomas disponibles
To get the best possible performance from your chain saw it is
important to keep the teeth of the chain sharp. Follow these helpful
tips for proper saw chain sharpening:
1. For best results use a 4.5mm file and a file holder or filing guide
to sharpen your chain. This will ensure you always get the correct
sharpening angles.
2. Place the file holder flat on the top plate and depth gauge of the cutter.
3. Figure
23-
Keep
the correct top plate
(S) filing angle line of
30° on your file guide
parallel with your chain
(file at 60° from chain
viewed from the side).
4. Sharpen cutters on
one side of the chain first. File from the inside of each cutter to
the outside. Then turn your saw around and repeat the processes
(2,3,4) for cutters on the other side of the chain.
note:
Use a flat file to file
the tops of the rakers (portion
of chain link in front of the
cutter) so they are about .025
inch (.635 mm) below the tips
of the cutters as shown in
figure 24.
5. Figure 25- Keep all
cutter lengths equal.
FIG. 25
6. If damage is present
on the chrome surface
of the top plates or
side plates, file back
until such damage is
removed.
FIG. 23
S
FIG. 24
.025 in.
.635mm
CAUTION:
extra caution during this process.
note:
Each time the chain is sharpened, it loses some of the
low kickback qualities and extra caution should be used. It is
recommended that a chain be sharpened no more than four times.
Accessories
WARNING:
60°
recommended in this manual may be hazardous.
Replacement chain and bar are available from your nearest D
authorized service center. For use only with low kick back bar and
chain.
• DCCS690 uses replacement chain, service part number 90618541
or Oregon replacement chainsaw chain R56. Replacement 16"
bar, service part number 90618542.
repairs
The charger and battery pack are not serviceable. There are no
serviceable parts inside the charger or battery pack.
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustments (including brush inspection and replacement) should
be performed by a D
authorized service center or other qualified service personnel. Always
use identical replacement parts.
register online
Thank you for your purchase. Register your product now for:
• Warranty SerVICe: Registering your product will help you
obtain more efficient warranty service in case there is a problem
with your product.
• ConfIrMatIon of oWnerSHIP: In case of an insurance
loss, such as fire, flood or theft, your registration of ownership will
serve as your proof of purchase.
19
After filing, the cutter will be sharp, use
T h e u s e o f a c c e s s o r i e s n o t
WALT factory service center, a D
e
WALT
e
WALT
e
Tabla de contenido
