DeWalt DXPW4240 Manual De Instrucciones página 15

NOTICE: Risk of property damage. Failure to do so could cause
damage to the pump.
10. Remove all air from the pump and high pressure hose by depressing
trigger until a steady stream of water is present.
11. Turn the engine ON/OFF switch (H) to the ON position.
12. Place the fuel valve lever (M) in the ON position.
13. If the engine is cold, move the choke (L) to the CLOSED position
as shown.
FIG. 13 FIG. 14
H
14. WARNING: Risk of unsafe operation. Pull starter grip slowly
until resistance is felt. Then pull starter grip (I) rapidly to avoid
kickback and prevent hand or arm injury.
NOTE: Do not allow the starter grip to snap back. Return it gently by
hand.
WARNING: Risk of unsafe operation. If engine does not start after
two pulls, squeeze trigger of gun to relieve pump pressure. Pull starter
cord slowly until resistance is felt. Then pull cord rapidly to avoid
kickback and prevent hand or arm injury.
FIG. 15
L
M
NOTE: If the oil level in the engine is low, the engine will not start. If
the engine does not start, check the oil level and add oil as needed.
15. As the engine warms up, move the choke to the OPEN position.
FIG. 16
16. Depress trigger on gun to start water flow.
WARNING: Do not allow the unit to run for more than two
minutes without the gun trigger being pulled. This could cause
overheating and damage to the pump. When the temperature
inside the pump rises too high, the thermal relief valve will
open and release a spray of water from the pump to lower the
internal temperature. The valve will then close.
WARNING: Risk of unsafe operation. Stand on a stable surface
and grip gun/wand firmly with both hands. Expect the gun to kickback
when triggered.
17. Release trigger to stop water flow.
DANGER: Risk of injury from spray. Engage the trigger lock (X)
when gun is not in use to prevent accidental spraying.
18. Adjust spray for the task being performed by changing quick
connect nozzle. Refer to Spray Wand Nozzles.
15
FIG. 17
X