Basic Menu - schmalz CobotPump ECBPi Manual De Usuario

The following table shows the assignment of the electrical connection options in the operating modes SIO and IO-
Link:
M12 connec- Pin
tor / terminal
block
ECBPi M12-8 1
2
3
4
5
ECBPi TB-8
6
7
8
6 Operation
6.1 Basic Menu
All settings for standard CobotPump applications can be made and observed using the basic menu.
1. Open the basic menu by pressing the
2. Use or to select the desired adjustable parameter.
3. Confirm the selection with the
4. Use the or
5. To save and exit the menu, press and hold the
ð The displayed value flashes to confirm.
The following table shows an overview of the display codes in the basic menu:
Code Parameter
x-1
Limit value H1
5PE
Capacity
x-2
Limit value H2
h-2
Hysteresis values h-2
tbL
Ventilation time
CAL
Zero-point adjustment
(calibration)
EN-US · 30.30.01.01506 · 01 · 02/18
Symbol Function with SIO
U Power supply for actuator
A
U Power supply for sensor
s
GND Actuator ground
A
IN "Suction" signal input
1
OUT "Parts control" signal output (H2)
2
IN "Vent" signal input
2
GND Sensor ground
S
OUT CM (Condition Monitoring)
3
key.
keys to set the value of the parameter.
Explanation
Deactivation value of control function
(only if ctr = on is active)
Indicates the percentage of the max. pump capacity
(only if ctr = off is active and can be set)
Switching value of "Parts control" signal output
(when NO output is configured)
Hysteresis value of "Parts control" signal output
Ventilation time setting for internal, time-controlled blow off
(only if blo = 1-t or E-t is active)
Calibrate vacuum sensor, zero point = ambient pressure
key.
key for at least 2 seconds.
Function with IO-Link
—
IO-Link communication
—
—
5 / 9