ADInstruments AD300 Manual De Usuario página 154

_____________________________________________________________________
B. If the [mode] is set to Normal, the following parameters will be
displayed in each page.
Parameter
Fiber Type
Align
X image focus
Y image focus
Fiber leaning core
compensation function
Arc auto adjustment
Proof Test
Cleave Limit
Core Angle Limit
Parameter
©Copyright Abacanto Digital SA.
A list of splice modes stored in the splicer database is
displayed. Upon inputting the appropriate mode, the
selected splice mode stored in database area is copied
to a selected splice mode in user-programmable area.
Sets the aligning method for the fibers.
"Core": Aligns fibers by core position.
"Clad": Aligns fibers by center position of the cladding
of the fiber.
"Manual": Aligns fibers manually.
This function is set as "Auto" and can not be changed
by the user. Each time before fibers are forwarded and
aligned, left and right fibers are focused independently;
therefore optimum focusing can be achieved even if
different fibers are spliced (dissimilar fiber splicing).
This function is set as "Auto" and can not be changed
by the user. See X image focus.
If [Proof Test] is set to "ON", a proof-test is performed
automatically.
An error message is displayed if the cleave angle of
either the left or right fiber ends exceed the selected
threshold (Cleave limit).
An error message is displayed on the screen if the bend
angle of the two fibers spliced exceeds the selected
threshold (Core Angle Limit).
Manual de usuario AD300
AD Instruments
Description
Description
154