ADInstruments AD300 Manual De Usuario página 121

_____________________________________________________________________
<4> The fourth screen in the "editing splice mode" menu:
Parameter
Cleaning Arc
Gap
Gapset Pos.
Pre-fusion Power
Pre-fusion Time
Overlap
©Copyright Abacanto Digital SA.
A cleaning arc burns out micro dust on the surface of the fiber
with an arc discharge for a short period of time. The
duration of the cleaning arc can be changed by this parameter.
Sets the end-face gap between the left and right fibers at the
time of aligning and pre-fusion discharge.
Sets the relative position of the splicing location to the center
of electrodes. Splice loss may be improved in the case of
dissimilar fiber splicing by shifting [Gapset Pos] towards a
fiber whose MFD is bigger than the other fiber MFD.
Sets the power of the pre-fusion arc, which is an arc discharge
occurring from the beginning until the fibers begin stuffing.
If [Pre-fusion Power] is set too low, axial offset may occur if
cleaved angles are relatively poor. If [Pre-fusion Power] is
set too high, fiber end faces are fused excessively and splice
loss gets worse.
Sets the duration of the pre-fusion arc, which is arc discharge
occurring from the beginning until the fibers begin stuffing.
Longer [Pre-fusion Time] is synonymous with higher
[Perfusion Power].
Sets the overlap amount of fibers at the fiber stuffing stage.
Relatively small [Overlap] is recommended if the [Pre-fusion
Power] is low, while relatively large [Overlap] is
recommended if the [Pre-fusion Power] is high.
Manual de usuario AD300
AD Instruments
Description
121