ADInstruments AD300 Manual De Usuario página 111

_____________________________________________________________________
Fiber stripping
Clean
2.7.3 Aim the edge of the fiber coating layer at the "16"calibration
of the cutter yardstick and put the fiber into orientation
pressure tank with the left hand, and be sure that the bare
fiber has been straightly put on the right and left rubber pads.
2.7.4 Close the small clip, big clip by right hand and promote sliding
plate installed with blade to the other side, and then cut the
fiber.
©Copyright Abacanto Digital SA.
Manual de usuario AD300
AD Instruments
111