Tabla de contenido
Idiomas disponibles

Idiomas disponibles

ENGLISH
Problem
DRIVE PEDAL
The machine moves even if the drive pedal is
released
CAB HEATING
There is no hot air
CAB CLIMATE CONTROL SYSTEM
There is no fresh air
DIESEL ENGINE
When turning the ignition key, the engine does
not start
NOTE
For diesel engine complete troubleshooting, see the relevant Manual.

SCRAPPING

Have the machine scrapped by a qualified scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
law in force:
Brooms
Engine oil
Hydraulic system oil
Hydraulic system oil filters
Plastic components
Electrical and electronic components - Battery
NOTE
Refer to the nearest Nilfisk Center especially when scrapping electrical and electronic components.
36
INSTRUCTIONS FOR USE
Possible cause
The drive pedal is misadjusted
The valve or the hot water feed hoses are
broken
There are water leaks from the heater
The switch is deactivated
The fuse is blown
The compressor does not turn because the
drive belt is loosen/broken
There are gas leaks from the system
The expansion valve is faulty
The switch is deactivated
The fuse is blown
There is an open in the gas pressure switch
The relay is burnt
The drive pedal is pressed
33015498(3)2008-02
Remedy
Adjust
Replace
Replace
Activate
Replace
Adjust the tension/replace the belt
Repair the leak and integrate the gas
Replace
Activate
Replace
Replace
Replace
Do not press the drive pedal when starting the
engine.
RS 501
Tabla de contenido
loading

Tabla de contenido