Description - Hilti AG 180-20 D Manual De Instrucciones

Obligation signs
Wear Wear a hard
protective
glasses
en
Wear
breathing
protection
Symbols
Read the Return waste
operating material for
instructions recycling.
before use
Hertz Watts
Revolutions Revolutions
per minute per minute

2 Description

2.1 Use of the product as directed
The power tool is designed for cutting and grinding metal and mineral materials without use of water.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
The power tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type identification plate.
Working with metals: Cutting, grinding.
Working with mineral materials: Cutting, slitting and grinding.
Use only discs (abrasive grinding discs, abrasive cutting discs, etc.) that are approved for use at a speed of at least
8500/min, with a maximum thickness of 6.4 mm (grinding discs) or 2.5 mm (cutting discs) and a diameter of max.180
mm.
Use only synthetic resin-bonded, fiber-reinforced grinding discs or cutting discs approved for use at a permissible
peripheral speed of at least 80 m/sec.
The power tool may be used only for dry cutting or grinding.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
Take the influences of the surrounding area into account. Do not use the power tool or appliance where there is a risk
of fire or explosion.
Nationally applicable industrial safety regulations must be observed.
16
Wear ear
hat protection
Volts
Alternating
current
Diameter
Location of identification data on the power tool
The type designation and serial number can be found
on the type identification plate on the machine or tool.
Make a note of this data in your operating instructions
and always refer to it when making an enquiry to your
Hilti representative or service department.
Wear
protective
Type:
gloves
Generation: 03
Serial no.:
Amps
Rated speed
Double
insulated