Optional Accessories; After Use - Makita DLS600 Manual De Instrucciones

The movable range of laser line is decided by the range
adjustment screws on both sides. Perform following
procedures to alter the laser line position.
1. Remove the battery cartridge.
2. Draw a cutting line on the workpiece and place it
on the turn base. At this time, do not secure the work-
piece with a vise or similar securing device.
3. Lower the handle and align the cutting line with
the saw blade.
► Fig.62: 1. Cutting line
4. Return the handle to the original position and
secure the workpiece with the vertical vise so that the
workpiece does not move from the position you have
determined.
► Fig.63: 1. Vise
5. Install the battery cartridge to the tool and turn on
the laser switch.
6. Loosen the adjusting screw. To move the laser line
away from the blade, turn the range adjustment screws
counterclockwise. To move the laser line close to the
blade, turn the range adjustment screw clockwise.
Adjusting the laser line on the left side of the blade
► Fig.64: 1. Adjusting screw 2. Range adjustment
screw 3. Hex wrench 4. Laser line 5. Saw
blade
Adjusting the laser line on the right side of the
blade
► Fig.65: 1. Range adjustment screw 2. Hex wrench
3. Laser line 4. Saw blade
7. Slide the adjusting screw to the position that the
laser line comes onto the cutting line and then tighten.
NOTE: The movable range of laser line is factory
adjusted within 1 mm from the side surface of blade.
Cleaning the laser light lens
The laser light becomes hard to see as the lens for
the laser light gets dirty. Clean the lens for laser light
periodically.
Remove the battery cartridge. Loosen the screw and
pull out the lens. Clean the lens gently with a damp soft
cloth.
► Fig.66: 1. Screw
► Fig.67: 1. Lens
NOTICE:
Do not remove the screw which
secures the lens. If the lens does not come out,
loosen the screw further.
NOTICE:
Do not use solvents or any petro-
leum-based cleaners on the lens.

After use

After use, wipe off chips and dust adhering to the tool
with a cloth or the like. Keep the blade guard clean
according to the directions in the previously covered
section titled "Blade guard". Lubricate the sliding por-
tions with machine oil to prevent rust.
OPTIONAL
ACCESSORIES
WARNING:
attachments are recommended for use with your
Makita tool specified in this manual. The use of
any other accessories or attachments may result in
serious personal injury.
WARNING:
or attachment for its stated purpose. Misuse of
an accessory or attachment may result in serious
personal injury.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Carbide-tipped saw blades
• Holder rod assembly
• Set plate
• Shoulder strap
• Makita genuine battery and charger
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
24 ENGLISH
These Makita accessories or
Only use the Makita accessory