Tabla de contenido
Interconnections
The following figure shows the Monitorr's intercon-
nections.
Network Connector (RS 485)
Network connector (RS-485)
In order to have the IP-54 environment protection
use the appropriate connector provided.
To wire the MoniTorr network please connect all
the A+ terminal toghether and the same for B- and
Gnd terminals.
Transmission Channel Characteristics
Type:
RS-485 2-wire (gnd optional)
half duplex
levels:
RS 485
baud rate:
115200/57600/38400
19200/9600/4800
2400/1200/300/110
programmable
character length: 8 bits
parity:
none
stop bit:
1 bit
protocol:
master (PC) / slave (MoniTorr).
Installing the File Download Software
The MoniTorr connectivity kit comes with the soft-
ware needed to transfer via RS-485 all the data
stored. To install the software simply insert disk-
ette No. 1 into the personal computer drive and
run the Setup program.
If the personal computer uses with Windows 2000
Professional Operating System, copy the three
diskettes into a temporary directory in the PC and
then run the W2000.bat file from the hard disk.
In the two cases the following screen will be dis-
played on the personal computer:
Close all the applications and then select OK. The
following screen will now be displayed on the per-
sonal computer monitor:
It is suggested that you maintain the proposed di-
rectory and path so as to facilitate the identification
of the files generated by the system.
Click on the figure to continue with the installation.
At this point the following screen is displayed on
the personal computer monitor.
83
TECHNICAL INFORMATION
NOTE
87-900-968-01(C)
Tabla de contenido
