Replace The Cutting Line; Replace The Bump Knob - GreenWorks Pro 2103902CT Manual Del Operador

10. Push the spool cover until it clicks into position.
9.4

REPLACE THE CUTTING LINE

NOTE
Remove the remaining cutting line on the spool.
NOTE
Use only with the nylon cutting line of 0.080" (2 mm)
diameter.
1. Cut a piece of cutting line approximately 3m long.
2. Bend the line at the midpoint and hook the loop into
the slot in the center rim of the spool. Make sure
that the line snaps into position in the slot.
3. With your finger between the lines, wind the lines
equally and tightly around the spool in the indicated
direction.
English
4. Put the lines in the guide slots.
5. Do not wind the lines beyond the edge of the spool.
9.5
1. Push the tabs on the sides of the trimmer head at
Slot
2. Pull and remove the spool cover.
3. Remove the spool.
11

REPLACE THE BUMP KNOB

the same time.
EN
Cover
Spool
Tab