General Information; Clean The Machine; Replace The Spool - GreenWorks Pro 2103902CT Manual Del Operador

EN
Use only the replacement parts and accessories of the
initial manufacturer.
9.1

GENERAL INFORMATION

Only your dealer or approved service center can do
the maintenance that is not given in this manual.
Before the maintenance operations:
• Stop the machine.
• Remove the battery pack.
• Cool the motor.
• Store the machine in cool and dry place.
• Use correct clothing, protective gloves and safety
glasses.
9.2

CLEAN THE MACHINE

• Clean the machine after use with a moist cloth
dipped in neutral detergent.
• Do not use aggressive detergents or solvents to
clean the plastic parts or handles.
• Keep the trimmer head free of grass, leaves, or
excessive grease.
• Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
• Do not spray water onto the motor and electrical
components.
9.3

REPLACE THE SPOOL

1. Push the tabs on the sides of the trimmer head at
the same time.
2. Pull and remove the spool cover.
3. Remove the remaining spool.
IMPORTANT
IMPORTANT
Tab
English
4. Clean dirt and debris from all parts. Replace spool if
it is worn or damaged.
5. Replace with a pre-wound spool, or replace the
cutting line.
6. Put the new spool in the spool cover.
Make sure that you put the cutting line in the slot on
the new spool and extend the line approximately 15
cm before you install the new spool.
7. Put the ends of the cutting lines through the holes.
8. Extend the cutting line to release it from the guide
slot in the spool.
9. Push the tabs and install the spool cover onto the
spool housing.
10
Cover
Spool
Tab
NOTE