Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
Make sure that all nuts, bolts and screws are tight.
Examine regularly that you install the handles tightly.
Use only the replacement parts and accessories of the
initial manufacturer.
10.1 GENERAL INFORMATION
Only your dealer or approved service center can
perform maintenance that is not given in this manual.
Before the maintenance operations:
•
Stop the machine.
•
Remove the battery pack.
•
Cool the motor.
•
Store the machine in cool and dry place.
•
Use correct clothing, protective gloves and safety
glasses.
10.2 CLEAN THE MACHINE
•
Clean the machine after use with a moist cloth
dipped in neutral detergent.
•
Do not use aggressive detergents or solvents to
clean the plastic parts or handles.
•
Keep the trimmer head free of grass, leaves, or
excessive grease.
•
Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
•
Do not spray water onto the motor and electrical
components.
10.3 REPLACE EXCESS LINE
1. Push the tabs (18) on the sides of the trimmer head
at the same time.
2. Pull and remove the spool cover (19).
IMPORTANT
IMPORTANT
IMPORTANT
18
English
3. Remove the remaining spool (21).
4. Clean dirt and debris from all parts. Replace spool if
it is worn or damaged.
5. Push the tabs and install the spool cover onto the
spool housing.
6. Push the spool cover until it clicks into position.
10.4 INSTALL THE CUTTING LINE
Do not put more than 15 feet of cutting line in at a
time.
1. Remove the remaining cutting line on the spool.
10
18
20
21
23
22
NOTE
19
Capítulos
Tabla de contenido
Solución de problemas
