Blower Operation; Stopping The Engine - Maruyama BL55 Manual Del Propietário

STEP #4) Warming up the engine.
When the engine has started, slowly move
the "CHOKE LEVER" fully upward to the
open position.
"WARM-UP" at less than 1/2 speed.
If a MARUYAMA engine fails to start after following the above procedures, contact an authorized
MARUYAMA dealer.

BLOWER OPERATION

When the engine has warmed-up, the power blower can be positioned on the back of the operator.
When the power blower is positioned and ready for operation, adjust the throttle to a speed
required to accomplish the task.
WARNING
• Never operate a power blower when you are fatigued.
• Never operate a power blower without proper guards or other protective safety devices in place.
WARNING
To prevent overheating and engine seizure, cooling air comes from the intake grille of the fan
housing and is pushed by the blower fan through an opening in the fan housing over the cylinder fin
area, taking away combustion heat. The grille and cylinder fins must be kept clean of grass, dust
and any debris. Engine failure due to lack of this "Normal Maintenance" is not covered by warranty.

STOPPING THE ENGINE

Always run the engine at idle speed for a few minutes to allow cooling before stopping. To stop the
engine, move the throttle control lever all the way to the engine stop position, or move the stop
switch to the "STOP" position.
Allow the engine to
Intake grille of the
blower housing
OPERATING POSITION
— 12 —
OPEN
English