Assembly; Tools Needed - WAGNER CONTROL PRO 190 Manual Del Propietário

ASSEMBLY

Do not plug in the power cord until assembly is complete.

TOOLS NEEDED

•
Two 6" adjustable wrenches
1.
Attach the tool box doors to the top of the sprayer as shown. Snap one
peg into one of the orifices, and then snap the other peg into the other
orifice. The pegs on the ends will snap into the orifices on the unit.
2.
STAND MODELS - Attach the handle:
Line up the handle with the frame as shown. Push the snap buttons
on each side and drop the handle into the frame. The snap-buttons will
secure the handle into place.
3.
CART MODEL - Pull out the handle from the cart frame. Once it reaches its
maximum height, it will snap into place. To push it back into the frame,
push the snap buttons on the back of the frame.
4.
Remove the plug from inside the hose fittings and remove the cap on the
spray hose port. Discard both.
5.
If equipped, screw the pressure gauge to the spray hose port.
6.
Thread one end of the high pressure spray hose to the spray hose port.
Hold the port with an adjustable wrench, and tighten the hose with the
other. Do not over-tighten.
8
4
6
EN
1
2
3
5
OR