Stretch The Fabric; Cut The Fabric - Petsafe 7126 Instrucciones De Montaje

Step

Stretch the Fabric

8
1. Starting from the fi rst post away from the gate, use a hammer to stretch
the fabric as shown.
2. Stretch fabric as tightly as possible. Add tie wires to posts to hold the
stretched fabric.
Important: Be sure all tie wires are on the same picket (wire) or
the fabric will be crooked.
3. Stretch and tie to the next post, until you go all the way around. Don't tie
the last post (at the gate).
________________________________________________________________________________________________

Cut the Fabric

Step
1. Gather 5 clips and 1 tension rod.
9
2. Stretch the fabric as tightly as possible to the last post and select a fabric
wire to cut, allowing 4 ½" for the tension rod and clips (9A).
3. Cut the fabric by holding the fabric loosely while you spin one of the pickets out.
a. Undo the knuckle at the top and the knuckle at the bottom of the
same picket (9B).
b. Unweave that picket by spinning it out (9C). Be careful! Wire ends
are sharp.
c. Install the tension rod (9D) and 5 clips (9E).
9B
8
9C
1-888-632-4453
9A
Remove this picket
1
4 / "
2
9D
9E