5- Domopools; General Considerations; Installation - BSV BS Pool EVOLINK Serie Manual De Usuario

b) Low water temperature operation: Don't keep the system work in
low water temperature conditions (under 15ºC). As an alternative, there
are some hibernation products that keeps the water in good conditions in
winter time. If you still want to use it in low water conditions, please
consider to reduce the maximum production value, for example, set it at
50% instead of 100%.
c) Automatic cleaning cycles: The time between automatic cleanings
can be adjusted, so it can be adapted to the water hardness of your
swimming pool. The chlorinator is configured by default to 4 hours. If
your swimming pool water is very hard, you can decrease this value, so
the automatic cleanings will perform more frequently, but the lifespan of
the cell will be reduced. On the other hand, if the water is soft, you can
increase the cleaning time cycle, and the cell's lifespan will be increased.
d) Deficient cleaning: If you observe calcium deposits between the cell
electrodes, clean it as shown in the 6.1 section. Don't allow to keep the
cell working in these conditions for a long time.

5- DOMOPOOLS

5.1- General Considerations

DOMOPOOLS system integrates a domotic control to set chemical parameter of
swimming pool
There are four programmable relays available for plugging any extra devices.
Manually or automated controlled
DOMOPOOLS requires WiFi signal of Ethernet cable for remote control.
Radiofrequency Communication is the way to connect DOMOPOOLS and
EVOLINK. We recommend an indoor installation for DOMOPOOLS, keep in mind
any obstacles may reduce your radio link to EVOLINK
5.1.2- Main features
• Check chlorinator status
• Monitoring probe readings
• Chlorinator set point control
• Configuration and program of relays
• History log of probe readings

5.2- Installation

Wifi connection or Ethernet cable(RJ45) to Internet is required to achieve a
correct installation.
5.2.1- Configuration and Local connection
Manual EVOLINK v.5
106 / 120