Care And Maintenance; Cleaning And Drying; Hilti Calibration Service; Troubleshooting - Hilti PP 10 Manual De Instrucciones

8. Care and maintenance

8.1 Cleaning and drying

1. Blow dust off the lenses.
2. Do not touch the glass with your fingers.
3. Use only a clean, soft cloth for cleaning. If
necessary, moisten the cloth slightly with pure
alcohol or a little water.
NOTE Do not use any other liquids as these may
damage the plastic components.
4. Observe the temperature limits when storing
your equipment. This is particularly important in
winter / summer if the equipment is kept inside
a motor vehicle (-30°C to +60°C).
8.2 Storage
Remove the tool from its case if it has become wet.
The tool, its carrying case and accessories should be
cleaned and dried (at maximum 40°C / F). Repack the
equipment only once it is completely dry.
Check the accuracy of the equipment before it is used
after a long period of storage or transportation.
Remove the batteries from the tool before storing it
for a long period.

9. Troubleshooting

Fault
E02/03
E99
ERROR
Printed: 07.07.2013 | Doc-Nr: PUB / 5070160 / 000 / 00
8.3 Transport
Use the Hilti toolbox or packaging of equivalent quality
for transporting or shipping your equipment.
CAUTION
Always remove the batteries before shipping the
tool.

8.4 Hilti calibration service

We recommend that the tool is checked by the Hilti
calibration service at regular intervals in order to
verify its reliability in accordance with standards and
legal requirements.
Use can be made of the Hilti calibration service
at any time, but checking at least once a year is
recommended.
The calibration service provides confirmation that the
tool is in conformance, on the day it is tested, with
the specifications given in the operating instructions.
The tool will be readjusted if deviations from the
manufacturer's specification are found. After check-
ing and adjustment, a calibration sticker applied to
the tool and a calibration certificate provide written
verification that the tool operates in accordance with
the manufacturer's specification.
Calibration certificates are always required by com-
panies certified according to ISO 900x.
Your local Hilti Center or representative will be pleased
to provide further information.
Possible cause
An internal measurement problem
has occurred.
An internal memory problem has
occurred.
The tool was moved while in
standby mode.
Remedy
Switch the tool off and then on
again. An error message may be
displayed if the tool is knocked or
shaken. In this case, eliminate the
cause of the disturbance.
Switch the tool off and then on
again.
Switch the tool off and then on
again and check that it is set up
correctly.
NOTE
Contact your nearest Hilti Service
Center if the fault persists.
en
29