Charging Status; Operation - Hilti PP 10 Manual De Instrucciones

6.7 Charging the PPA 82 battery
Charging should take place in a room where the
temperature is between +10 C and +40 C.
The battery is charged automatically when the laser
is operated at a temperature of [+10 C to +40 C] with
an external battery.
1. Fit the PPA 81 charging adapter to the PPA 82
en
battery.
2. Connect the power supply unit to the charging
adapter.
3. Plug the power supply unit into a power outlet.

6.9 Charging status

Charging status

7. Operation

7.1 Button functions 4
1 Plumb spot button
2 Laser beam mode button
3
"Lock" button
4 Target plate auto-centering
button
5 Direction control
5 Parameter selection
5 Automatic centering
6 Laser beam up / down
6 Value entry
7 SET button
8
ON / OFF button
24
Printed: 07.07.2013 | Doc-Nr: PUB / 5070160 / 000 / 00
4. Check that the correct voltage has been set on
the power supply unit.
The charging control lamp lights green when the
charging operation is complete.
6.8 Replacing the batteries in the PPA 20
remote control unit
1. The cover on the rear of the remote control unit
moves when pushed in the direction of the arrow.
Remove the cover in order to gain access to the
batteries.
2. Remove the 4 old batteries and replace them
with new ones.
3. Push the cover back into position until it engages.
Red LED lights
Green LED lights
Blinks green
Blinks red
Switches the plumb spot on and off (switches off automatically after
30 minutes).
The laser beam can be switched over by pressing the laser beam
mode button. PP 10: constant beam or blinking beam PP 25: con-
stant beam, blinking beam, high-power mode
This button locks all data entry functions. Values can then no longer
be changed. The data entry functions can be unlocked by pressing
the LOCK button again.
The laser beam finds the center of the target plate automatically.
Moves the laser beam to the left or right.
Used to select the parameters to be set.
The laser beam centers itself automatically when both direction con-
trol buttons are pressed at the same time.
Moves the laser beam up or down.
Positive or negative values may be entered. When both buttons
are pressed at the same time, inclination is set automatically to
00.000%.
This button is used to confirm the selected parameters.
This button is used to switch the tool on or off.
Charging
Charging completed
Error during charging
The protective cut-out has been ac-
tivated. The PP 10/25 may be used
while in this status.