Dometic WAECO PerfectView Serie Instrucciones De Montaje página 32

Installing the LCD monitor
Observe the following instructions when laying the connection cable:
 If possible, use original ducts for laying the cables, or other suitable options, such as
ventilation grilles. If there are no existing ducts, you must drill a hole of ∅ 22 mm.
Check beforehand that there is sufficient space on the other side for the drill head to
emerge (fig. 2, page 4).
 Cover the holes with the feed through (fig. b 1, page 7) in the base of the monitor
bracket.
 To prevent damage to the cables, when laying them ensure that there is always
sufficient distance to vehicle components which can become hot (lights, heaters,
ventilators etc.).
 When laying the cables (fig. 3, page 4), make sure:
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp-edged ducts without protection.
Connecting the monitor as a reversing video system (fig. d, page 8)
➤ Lay the connection cable for the monitor bracket on the dashboard.
➤ Insert the plug of the monitor cable (2) into the socket (4) of the connection cable (3).
Wait until you hear the plug snap in.
A
NOTICE! Beware of damage
Make sure the polarity is correct when connecting to a voltage source.
➤ Connect the red and black cables of the connection cable to a suitable voltage supply:
– Connect the red cable (5) to terminal 15 (ignition).
– Connect the black cable (6) to terminal 31 (earth).
➤ If the monitor is to be activated when reverse gear is selected, connect the green
cable (7) to the positive cable of the reversing light.
I
NOTE
If voltage is present in the green cable (7), the reversing camera will be
activated automatically. The reversing camera has priority.
➤ If the monitor is to be activated e.g. when the indicator is flashing, connect the
following control cable to a positive cable of the indicator:
– white cable (8)
I
NOTE
If voltage is present in this control cable, the video input CAM2 will be activated.
32
PerfectView M55L, M75L
EN