Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
NOTE: Before loading nails in the magazine, adjust
the plate. If the magazine cover is forcibly
closed without adjusting the plate correctly,
the nail holder may be damaged.
1 Turn the nail holder about 90 degrees
counterclockwise.
2 Slide in vertical direction possible.
Lift or lower the nail holder to accept different
length nails.
3 Adjust the plate to the nail length reference points
on the magazine cover and turn the nail holder 90
degrees clockwise until you hear "click".
Magazine
2
3
(3) Place the nail coil into the magazine.
Uncoil enough nails to reach the driving hole.
Magazine
Nail holder
First nail
(4) 1 Insert the first nail into the driving hole and the
second nail between the two pawls of the feeder.
2 Fit the nail heads in the guide slot.
Driving hole
First nail
Nail guide
Pawl
1
NOTE: Be careful not to deform the collated wires and
not to disengage the nails with the guide surface.
Otherwise, the nail guide will not close correctly.
3 Pulling the nails to the right, swing the nail guide
closed.
(5) Lock the knob completely.
7
/
8
1
1-
/
4
2
1
Nail holder
Magazine cover
Nails
Guide slot
2
1
Feeder
Guide surface
LOADING CAPS (WASHERS)
When loading caps (washers) into Nailer,
disconnect air hose from the Nailer.
(1) 1 DISCONNECT AIR HOSE FROM NAILER.
2 Press the latch of the washer magazine cover with
your fingers and open the washer magazine cover.
Washer magazine cover
(2) Pull the caps slightly out of the reel then insert the reel
of caps in the washer magazine.
Washer magazine
(3) Guide the caps inside the washer rail and set in
position when the tip passes the reverse stopper tab.
— 14 —
WARNING
Lutch
Reel of caps
Second cap
Reverse stopper tab
Washer rail
Tabla de contenido
