DBI SALA 3400101 Manual De Istrucciones página 32

Ocultar thumbs Ver también para 3400101:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 86
Step 14. The pawl cover (H) (see Figure 3) must be secure and
without deformation. Optional mounting bracket must be
securely attached to SRL and free from defects. Detent
pin must operate freely.
INSPECTION STEPS FOR RETRIEVAL COMPONENTS: (MODELS
340854 AND 340855) See Figure 4
Step 11. Inspect the retrieval arm (E) for distortion or other
damage. Ensure that the retrieval handle (A) can be
rotated out and secured in the cranking position.
Step 12. Ensure the locking screw (D) can be tightened
completely.
Step 13. Ensure the shift knob (C) can be pulled out to the
unlocked position and then released, locking the crank
arm (E) in both the engaged and disengaged positions.
Step 14. Test the retrieval mode for proper operation by raising
and lowering a test weight of between 34-141 kg (sand
bag). Retrieval operation should be smooth and even.
When the retrieval handle (A) is released, the weight
should not move and the retrieval handle (A) should
remain in position (no movement). A "clicking" sound
should be evident when raising the load.
PROCEDURE FOR DEFECTIVE CONDITION: See GIUM Sec. 1.2.
IMPORTANT: Only Capital Safety or parties authorized in writing
may make repairs to this equipment.
8.0 PRODUCT LIFE
As long as the SRL passes inspection by a competent person
may remain in service. See GIUM 4.2 and Section 1.16 for warranty
information.
9.0 MAINTENANCE, STORAGE, TRANSPORT (See GIUM Sec. 3)
MAINTENANCE
◊ Position the SRL so excess water can drain out.
◊ Clean labels as required.
◊ Follow GIUM Sections 3.1 and 3.2. An excessive buildup of dirt,
paint, etc. may prevent the lifeline from fully retracting back into
the housing causing a potential free fall hazard. Replace lifeline
if excessive buildup is present.
1 Competent Person: An individual who is knowledgeable of a manufacturer's recommendations, instruc-
tions, and manufactured component who is capable of identifying existing and predictable hazards in
proper selection, use, and maintenance of fall protection.
32
, it
1
Tabla de contenido
loading

Este manual también es adecuado para:

34001023400301340030234005013400502

Tabla de contenido