DeWalt DCS350 Manual De Instrucciones página 13

1. Loosen both cutting die cap screws (K) counterclockwise using
the hex wrench (E) provided.
2. If your desired thread cutting size is overly worn, replace both with
a new cutting die set.
3. Position the cutting dies so that both stationary cutting die and
moveable cutting die are aligned with same thread size.
NOTE: Ensure that the dots on the cutting dies are facing toward
each other and they are seated against the two perpendicular
surfaces of the stationary cutting die (C) jaw and moveable cutting
die (D) jaw before tightening.
4. Tighten cutting die cap screws (K) clockwise using the hex
wrench (E).
5. Install a battery and cycle the tool to ensure proper assembly and
alignment prior to making a cut.
CAUTION: If the cutting die cap screws or hex wrench are lost or
damaged replace with identical replacement parts. Recommended
replacement parts for use with your tool are available at extra cost
from your local dealer or authorized service center. Always use
identical replacement parts
FIG. 3
K
E
D
K
C
OPERATION
WARNING: To reduce the risk of serious personal injury,
turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
WARNING: Cut Hazard. NEVER have any part of your body
near the cutters. Serious personal injury may occur.
WARNING: Cut Hazard. To reduce the risk of serious
personal injury, DO NOT use the threaded rod cutter with any
kind of accessory or attachment other than those recommended by
D WALT.
e
WARNING: Cut Hazard. Wear gloves when handling threaded
rod. The ends and threads can be sharp and can cause serious
personal injury.
Installing and Removing the Battery Pack
(Fig. 4)
NOTE: For best results, make sure your battery pack is fully charged.
To install the battery pack (G) into the tool handle, align the battery
pack with the rails inside the tool's handle and slide it into the handle
until the battery pack is firmly seated in the tool and ensure that it
does not disengage.
To remove the battery pack from the tool, press the release button (H)
and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual.
11