Renewing The V-Belt; Storage; Help In Case Of Malfunction - AL-KO solo Comfort 220 l Traducción Del Manual Original De Instrucciones

GB
13. Pull out the mower deck on the right side in
the direction of travel.

10.6 Renewing the V-belt

1. Release the locking nuts (6 pieces) (21/1).
2. Disconnect the V-belt duct (22/1).
3. Unhook and remove the right cover (23/1) of
the mower mechanism.
4. Unhook and remove the left cover (24/1) of
the mower mechanism.
5. Slightly release the screw (25/1) on the ten-
sioning pulley (25/2) until the V-belt (25/3)
can be fed out.
6. Remove the V-belt.
NOTE
The guidance and orientation of the V-
belt differs from type to type. Refer to
the information stickers on the mower
mechanism.
Inserting a new V-belt
1. Place the V-belt around the slightly loosened
tensioning pulley and screw the tensioning
pulley on again (27, 28).
2. Place the V-belt around the rollers in the se-
quence shown (27/a – d, 28/a – d), making
sure that the V-belt's guidance and position
are correct.

11 STORAGE

The lawn tractor should be parked where it is pro-
tected against the effects of weather, especially
Malfunction
Engine does not start. Lack of fuel.
46
Cause
Poor quality, contaminated fuel,
old fuel in tank.
Air filter contaminated.
No ignition spark.
Too much fuel in engine com-
bustion chamber due to repeated
starting attempts.
moisture, rain and lengthy exposure to direct sun-
light.
Never store the lawn tractor inside a building
when its fuel tank contains fuel, if there is poten-
tial for fuel vapours to come into contact with na-
ked flames or sparks. Only park the lawn tractor
in rooms that are suitable for the storage of motor
vehicles.
When storing the lawn tractor for long periods,
such as over winter, it should not have its fuel
tank filled if possible. The fuel can evaporate.
Before long-term storage, the fuel should be
drained from the tank and the carburettor in order
to avoid any build-up of deposits, which could re-
sult in problems when starting. Please contact
your specialist workshop for advice.

12 HELP IN CASE OF MALFUNCTION

CAUTION!
Risk of injury
Sharp-edged and moving appliance
parts can lead to injury.
■
Always wear protective gloves
during maintenance, care and clean-
ing work.
NOTE
For malfunctions that are not listed in
this table or that you cannot resolve
yourself, please contact our customer
service.
Remedy
Fill tank; check tank bleeding; check fuel
filter.
Always use fresh fuel from clean con-
tainers; clean carburettor (customer ser-
vice workshop).
Clean air filter (see operating instruc-
tions from engine manufacturer).
Clean the spark plug, replace with a
new one if necessary, check ignition ca-
ble, check ignition system (customer
service workshop).
Unscrew spark plug and dry off.
Storage