Connecting An Egc-Compatible Device - Oase InScenio EGC Controller Instrucciones De Uso

Connection
NOTE
The unit will be damaged, if water enters the plug connectors.
Screw the plug connectors to each other (socket/connector) so that they are water-

tight. Cover open plug connectors with a protection cap and rubber seal.
Ensure that the rubber seal is clean and fits exactly. Replace the rubber seal if it is

damaged.

Connecting an EGC-compatible device

The correct fastening of the plug connector is important for a secure connection and
an interference-free EGC network.
• The EGC connection cable is available as an accessory in the lengths 2.5 m (47038),
5 m (47039) and 10 m (47040).
– The EGC connection cable and the connection cable of the InScenio EGC Control-
ler are connected to the EGC cable connector. (47788).
• Ensure that on EGC-OUT of the last unit in the EGC network, the terminal resistor
EGC is installed instead of an EGC connection cable, to ensure that the EGC net-
work is closed off properly.
20
EGC0009
EGC0003