Installation And Connection; Installing The Device With The Ground Stake; Fastening The Device To The Wall; Connecting An Egc-Compatible Device - Oase InScenio EGC Controller Home Instrucciones De Uso

5

Installation and connection

W A R N I N G
Electrical current may cause death or severe injuries.
Ensure that the unit is installed in a flood protected position at a distance of at least 2 m from the wa-
ter.
5.1

Installing the device with the ground stake

How to proceed:
 C
1. Fully insert the ground stake into the ground.
2. Slide the device onto the ground stake.
3. Check its stability.
5.2

Fastening the device to the wall

How to proceed:
 D
1. Remove the retaining frame and fasten it to the wall using suitable screws.
2. Fit the device into the retaining frame.
Ensure that the device is properly engaged in the retaining frame.
5.3

Connecting an EGC-compatible device

The correct fastening of the plug connector is important for a secure connection and an interference-free EGC
network.
The EGC connection cable is available as an accessory in the lengths 2.5 m (47038), 5 m (47039) and 10 m
(47040).
The EGC connection cable and the connection cable of the InScenio EGC Controller are connected to the
EGC cable connector.
How to proceed:
 F, G
1. Remove the EGC terminal resistor from the unit.
2. Fit the plug connector and secure with the two screws (max. 2.0 Nm).
Ensure that the rubber seal is clean and fits exactly.
Replace the rubber seal if damaged.
3. Remove the protection cap from EGC-OUT of the last unit in the EGC network, fit the terminal resistor EGC
and secure it with the two screws (max. 2.0 Nm).
Ensure that on EGC-OUT of the last unit in the EGC network, the terminal resistor EGC is installed instead
of an EGC connection cable, to ensure that the EGC network is closed off properly.
The scope of delivery of InScenio FM-Master WLAN or InScenio EGC Controller each contains a terminal
resistor EGC.
N O T E
The device will be destroyed if water penetrates the sockets.
Close off sockets with plug connectors or protection caps and rubber seals.
For further information on the operation and integration into the EGC system, please refer to the oper-
ating manual of the InScenio EGC Controller under http://www.oase-livingwater.com/egc-start.
5.4

Connecting the power supply

How to proceed:
 E
1. Screw the plug of the supply line onto the transformer.
2. Establish the power connection.
- EN -
39