Specification And Performance Data Sheet - Bosch B22CS51SNS Instrucciones De Uso

en-us
Specification and Performance
Data Sheet
Only for appliances with filter model: 9000 777 508
When using replacement cartridge: 9000 674 655
The concentration of the indicated substances dissolved
in water entering the system was reduced to a
concentration less than or equal to the permissible limit
for water leaving the system as specified in ANSI/NSF
Standard 42 and Standard 53.
Contaminant Reduction
Average Influent
Influent Concentration
Avg. % Reduction
Average Product Water Concentra-
tion
Max Permissible Product Water
Concentration
NSF Reduction Requirements
NSF Test Report
* Based on the use of Cryptosporium parvum oocysts.
Application Guidelines/Water Supply Parameters:
Service Flow 0.75 gpm
2.83 lpm
Water Supply Potable Water
Water Pressure 30 - 120 psi
207 - 827 kPa
Water Tempera- 33 °F - 100 °F
ture* 0.6 °C - 38 °C
It is essential that the manufacturer's recommended
installation, maintenance and filter replacement
requirements be carried out. See manufacturer's
documentation for warranty information.
Note:
While the testing was performed under standard
laboratory conditions, actual performance may vary.
More detailed information on the prices of spare parts is
available from your appliance dealer or parts salesman
on site.
,
WARNING:
TO REDUCE THE RISK ASSOCIATED WITH
INGESTION OF CONTAMINANTS::
Do not use the system with water that is
microbiologically unsafe or of unknown quality
without adequate disinfection before and after
connecting to the system. Systems certified for
cyst reduction may be used on disinfected water
that may contain filterable cysts.
EPA Establishment Number 10350-MN-005
,
CAUTION:
To reduce the risks associated with property
damage due to water leakage:
20
Chlorine Taste Particle Class 1 Particle
and Odor Size >/= 0.5 to <1.0 μm
2.1 mg/l 9,100,000 pts/ml
2.0 mg/l +/- 10% At least 10,000 particles/
ml
97.6% 98.8%
0.05 mg/l 111,817 pts/ml
N/A N/A
>/=50% >/=85%
J-00121313 J-00099871
System tested and certified by NSF Interna-
tional against ANSI/NSF Standard 53 and
Standard 42 for the fulfilment of the require-
ments specified on this Specification and Per-
formance Data Sheet.
Rated capacity: 739.68 gallons/2,800 liters
Contaminant reduction determined by NSF testing.
Cysts*
170,000 cysts/l
Minimum
50,000 cysts/l
99.99%
0.001 cysts/l
N/A
>/=99.95%
J-00109715
Read and follow User Instructions before
■
installation and use of this system.
Installation and use must comply with all state
■
and local plumbing codes.
Do not install the system if water pressure
■
exceeds 120 psi/827 kPa. If your water
pressure exceeds 80 psi, you must install a
pressure limiting valve.
Contact a plumbing professional if you are
■
uncertain how to check your water pressure.
Do not install the system where water hammer
■
conditions may occur. If water hammer
conditions exist, you must install a water
hammer arrester. Contact a plumbing
professional if you are uncertain how to check
for this condition.
Do not connect the system to hot water supply
■
lines. The maximum operating water
temperature of this filter system is 100 ºF/33
ºC.
Protect filter from freezing. Drain filter system
■
when temperature drops below 33 °F/1 °C.
Change the disposable filter cartridge in the
■
following cases:
Once the rated capacity has been reached, if
there is a noticeable reduction in flow rate, or
after six months at the latest.
Manufactured by:
3M Purification Inc.
■
400 Research Parkway
Meriden, CT 06450
Tel. (800) 222-7880
Tel. (203) 237-5541
3M is a trademark of the 3M Company used under
license.
NSF is a trademark of NSF International.
© 2013 3M Company. All rights reserved.
Turbidity
11 NTU
11 +/- 1 NTU
98.1%
<1 NTU
0.5 NTU
95%
J-00099885