Instructions For Use (Qualified Personnel) - Ottobock BionicLink 60X7 Instrucciones De Uso

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 44
NOTICE
Operating the product very close to other electronic devices
Limited function due to product malfunction.
Do not stack the product during operation nor operate it in the immediate vicinity of other
electronic devices in operation.
If simultaneous operation cannot be avoided, monitor the product and verify proper use in
the existing setup.
NOTICE
Use of unapproved accessories
>
Limited function due to product malfunction as a result of reduced interference resistance.
>
Interference of other electronic devices due to increased emissions.
Use the product only in combination with the accessories, signal converters and cables lis­
ted in the section "Combination possibilities" (see Page 13).
INFORMATION
The BionicLink must be removed from the patient's leg orthosis following adjustment.
INFORMATION
The BionicLink cannot recognise any defects in the leg orthosis by itself. For this reason, attent­
ive observation by the orthopaedic technician and knowledge regarding the function of the leg
orthosis system are indispensable.
INFORMATION
The BionicLink is powered by the battery in the leg orthosis. For this reason, adjustments
should only be made when the battery in the leg orthosis is fully charged.
5 Scope of Delivery and Accessories
Scope of Delivery
1 pc. 60X7 BionicLink
1 pc. 4X183 wireless adapter cable BionicLink C-Brace
1 pc. hook-and-loop strap
1 pc. 647G782 instructions for use (qualified personnel)
Accessories
60X5 BionicLink PC
"4X180=V2.6 C-Soft" or higher adjustment software
6 Preparation for use
6.1 Preparing the BionicLink
The following steps only need to be carried out during first-time use.
1) Insert the wireless adapter cable plug into the BionicLink.
INFORMATION: The plug does not need to be removed again.
2) Insert the proper side of the hook-and-loop strap into the slots on the back of the BionicLink
(see fig. 1).
6.2 Attaching the BionicLink
1) Open the plug cover on the joint module (see fig. 2).
Ottobock | 15
Tabla de contenido
loading

Tabla de contenido