Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Personalised programming of the user
The programmer is shaped at the factory with a set of standard para-
meters.
The following user's guide deals with the modifiable options by the
final user, for such cases where a change of said parameters are required.
There are other options in the programmer, which can only be modi-
fied by the expert team of Lama for certain cases.
Never try to modify the parameters which are not shown in this
guide, as serious damage could be done and/ or cancel the guarantee
of the programmer.
Language, spanish
Programming screens
In order to have access to the menu of the user's programming, press
the two blue buttons (A and B) simultaneously ( ( f f i i g g u u r r e e 1 1 ) )
To go from one menu to another press the first blue button (A) of the
control panel (figure 2). The position of the cursor indicates the chosen
option in the menu.
• Introducing data into the FL4I programmer
In general, data is introduced into the programmer by pressing the
green button (D) which increases a unit (figure 3) and by pressing the
red button (C), a unit of the chosen option is reduced (figure 4)
The decimal data (Differential pressure) is modified by the green button (D) in creasing the decimals a unit (figu-
re 3) and by pressing the red button (C) the decimals are reduced a unit (figure 4).
LIMPIEZA HORARIA (cleaning time): It establishes the time taken between two cleaning cycles,
programmed by a clock.
DURACIÓN LAVADOS (duration cleaning proceses): Period of time between the beginning and
the end of a filter cleaning process, it can be programmed between 0 and 255 seconds.
T. ENTRE LAVADOS (time between cleaning proceses): Period of time between the end of a cle-
aning process and the beginning of the next, it can be programmed between 0 and 255
seconds.
FILTROS (filters): The filtering station indicates the number of filters the pad has.
TIEMPO INICIO M. (initial time M): Initial time of the master valve. It specifies the delay time
of the master valve until the beginning of the cleaning cycle. It can be programmed between
0 y 255 seconds.
TIEMPO FINAL M. (final time M): Time for ending the setting off of the master valve, in order
to avoid lower pressures at the end of the cleaning cycle. It can be programmed between 0 a
255 seconds.
TIEMPO P .D. (P.D time) .: Differential Pressure Time. It is the time of delay from the moment
the pressure difference is detected to the beginning of the cleaning cycle. It can be program-
med between 0 and 255 seconds: Tiempo de Presión Diferencial, tiempo de retardo desde que
la diferencia de presión es detectada y el inicio del ciclo de limpieza, programable entre 0 y
255 segundos
PR.DIFERENCIAL (Differential PR): Differential pressure, it is the difference between the inlet
pressure (P+) and the outlet pressure (P-) to start the cleaning cycles. It can be programmed
between 0.1 and 0.9 BAR
RELIEF: To avoid overpressure, the relief valve is set at factory to 7,5 Kg/cm². To change this value, consult your dea-
ler.
FL4A Mini Cleaning programmer - 220V/12V/115V
Figure 1
Figure 2
Figure 4
Figure 3
EN
27
Tabla de contenido
