Hood Assembly - Pleasant Hearth VFF-PH20LPB Manual Del Usuario

HOOD ASSEMBLY (IF REQUIRED)
WARNING: Always have screen in place before operating fireplace. This prevents
excessive temperatures on fireplace surfaces.
WARNING: Failure to position the parts in accordance with these diagrams or failure to
use only parts specifically approved with this fireplace may result in property damage
or personal injury.
Tools Required:
• Phillips screwdriver • scissors
1. If equipped, lift fireplace screen up and pull out to remove (See. Fig 2). Set screen aside until
installation has been completed.
2. Cut two plastic straps to remove log from firebox cavity. Set log aside.
3. An optional blower is available. See Accessories, page 38. Install optional blower now. Follow
installation instructions provided with blower.
4. Locate four black Phillips sheet metal screws in hardware packet.
5. Slide hood between louver and firebox top and align screw holes.
6. Insert screws as shown in Figure 3. Tighten screws firmly.
Shoulder Screw
Screen
Fig. 2 - Removing and Installing Screen
Carefully lift the insert through the center opening in the front of the fireplace. Slide the insert back
through the opening until the metal trim makes contact with the front of the mantel.
Louver
Sheet Metal
Screws
Hood
Fig. 3 - Assembling Hood
7
(If Required)
Firebox Top