CAMPAGNOLO NEUTRON Carbon Hub Manual De Uso página 42

6.3 - REMOVING THE FREEWHEEL BODY
Hold the axle steady by fully inserting a 5 mm Allen wrench on the freewheel side (Fig. 37) and completely
unscrew the nut by turning it clockwise with a 17 mm wrench as shown by the arrow marked on it; then remove the
small axle body.
6.4 - REMOVING AND REFITTING THE PAWLS
Remove the spring (taking care not to damage it) by slightly lifting pawl 1 (A - Fig. 38), slide out the pawls and
replace them if necessary, insert the bent part of the spring in the pawl carrier hole and then lock the pawls with
the spring (Fig. 39). Once the spring is installed, the pawls will be raised.
37
OPEN
38
A
19