Maintenance; Warranty - SPARKY Professional MBG 150 Instrucciones De Uso

WARNING: Never use accessories or attach-
ments differing from those recommended in this manual.
WARNING: Never sharpen or grind parts made
of aluminium, brass, or copper.
▪ While grinding, rest the machined piece against the
wheel front surface, do not grind on the wheel flat
side. Overloading the wheel side surfaces is danger-
ous and must not be attempted.
WARNING: In normal brushing operations, the
material being removed will fly off the brush with consider-
able force along with brush filaments which break off due
to fatigue. Do not operate the bench grinder unless the
eye shields are dropped down or without goggles.
▪ Avoid excessive pressure when using the brush.
Excessive pressure causes over-bending of the fila-
ments, filament breakage, and reduced brush life.
WARNING: Never exceed the recommended
Maximum Safe Free Speed R.P.M. (MSFS) rating of the
brush.
▪ Do not continue to use worn, torn or heavily clogged
sanding belts.
▪ Do not touch the moving sanding belt.
SWITCHING ON - SWITCHING OFF
Switching on: Press the START button "I" of the switch (6).
Switching off: Press the STOP button "O" of the switch (6).
ACCESSORIES
MBG 150, MBG 175, MBG 200, MBG 250: Raw wheel - 1
pc., finishing wheel -1 pc.
MBGT 150: Raw wheel - 1 pc., crimped wire wheel brush
with 0.3 mm brass filaments - 1 pc.
MBGS 200: Raw wheel - 1 pc., sanding belt - 1 pc.
WARNING: The bench grinder can be oper-
ated with other grit wheels with maximum allowable
wheel speed > 3000 min

Maintenance

WARNING: Always ensure that the tool is
switched off and unplugged before attempting to perform
inspection or maintenance.
This power tool does not require any special mainte-
nance. If the bench grinder should happen to fail despite
the care taken, please notify the authorised service
Original instructions
-1
centres for warranty and post-warranty servicing of
SPARKY power tools.
GENERAL INSPECTION
Regularly inspect all fasteners and ensure they are
properly tightened. Should any of the screws be loose,
retighten it immediately to avoid hazards.
If the replacement of the supply cord is necessary, this
has to be done by the manufacturer or his agent in order
to avoid a safety hazard.
CLEANING
Clean the spindle and the wheel guards from time to time
(Fig.12). Exterior parts may be cleaned with a damp cloth
and mild detergent if necessary.
Never use alcohol, petrol or other cleaning agent.
Never use caustic agents to clean plastic parts.
WARNING: Water must never come into contact
with the tool.

Warranty

The guarantee period for SPARKY power tools is deter-
mined in the guarantee card.
Faults due to normal wear, overloading or improper han-
dling will be excluded from the guarantee.
Faults due to defective materials implemented as well as
defects in workmanship will be corrected free of charge
through replacement or repair.
The complaints for defective SPARKY power tools will
be recognized if the machine is sent back to the dealer
or is presented to the authorised warranty service centre
undismantled, in its initial condition.
Notes
Carefully read the entire original instructions before us-
ing this product.
The manufacturer reserves the right to make changes
and improvements to the products and to alter specifica-
tions without prior notice.
Specifications may differ from country to country.
7
EN