COLLET REPLACEMENT
Unscrew nut 1 from spindle 2, replace the collet
and screw the nut.
ADjUSTING THE ROTATION SPEED
The rotation speed can be varied smoothly from
position A to G by turning electronic regulator 5,
placed on the rear of the grinder.
ACCESSORIES TO BE USED WITH
THIS POWER TOOL
Grinding wheel with Ø6 shank
Grinding wheel with Ø8 shank
Collet Ø6
Collet Ø8
Maintenance
WARNING: Always ensure that the
tool is switched off and unplugged before
attempting to perform inspection or mainte-
nance.
BRUSH REPLACEMENT
This power tool is equipped with auto-stop
brushes. When the carbon brushes are worn
out, the machine switches itself off. In this case
both brushes must be replaced simultaneously
with genuine brushes at SPARKY service centre
for warranty and post-warranty service.
GENERAL INSPECTION
Regularly inspect all fasteners and ensure they
are properly tightened. Should any of the screws
be loose, retighten it immediately to avoid haz-
ards.
If the replacement of the supply cord is neces-
sary, this has to be done by the manufacturer or
his agent in order to avoid a safety hazard.
Original instructions
All manuals and user guides at all-guides.com
CLEANING
For safe operation always keep the machine
and its ventilation slots clean.
Regularly check to see if any dust or foreign
matter has entered the ventilation slots and the
grills around the switches. Use a soft brush and/
or air jet to remove any accumulated dust. Wear
safety glasses to protect your eyes whilst clean-
ing.
Exterior plastic parts may be cleaned with a
damp cloth and mild detergent if necessary.
or other cleaning agent. Never use caustic
agents to clean plastic parts.
into contact with the tool.
IMPORTANT! To assure product safety and re-
liability, repairs, maintenance and adjustment
(including brush inspection and replacement)
should be performed by certified service centres
or other qualified service organisations, always
using genuine replacement parts.
WARNING: Never use alcohol, petrol
WARNING: Water must never come
7
EN