Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Programming –
NOTE: The unit will only brew on one side at a time. Single-serve side
cannot be used while Carafe side is programmed.
1. Time must be set before coffee maker can be programmed. Press
and pulse SET TIME button for correct hour in AM or PM. Wait
3 seconds. Pulse or hold to set minutes.
2. To program, press and hold PROG button. Start Time is visible in
display and 19:99 flashes as default.
3. While continuing to hold PROG button, pulse SET TIME button to
set desired brewing hour in AM or PM. Wait 3 seconds; minutes
will flash. Pulse to set minutes. Release PROG button. Press and
release PROG button again to activate automatic brew. PROG light
will illuminate.
TIP: To check the start time, press and hold the PROG button. The
time you set will be displayed and can be changed by repeating the
steps above. Press PROG button to reactivate automatic brew and the
light will illuminate.
Tips for Best-Tasting Coffee
• All coffees are made from either arabica beans or robusta beans,
or some combination of both. Arabica beans are slightly more
expensive, but tend to produce better-tasting coffee.
• Ground coffee will become stale much faster than whole beans.
If buying preground coffee, choose a package with the latest
expiration date or a smaller quantity.
• If grinding whole beans, set your coffee grinder on a fine/medium
grind. This will yield the best-tasting grounds. Try to use freshly
ground coffee within about a week of grinding.
• Using a water filter, filtered water, or bottled water will yield better-
tasting coffee than tap water.
• Use approximately 1 tablespoon (5 g) of grounds for each cup of
coffee being made. To avoid overflow, use slightly less grounds
(3/4 tablespoon [3.8 g]) when brewing decaf or flavored coffees.
Also, be aware that using coffee that is ground too finely may also
cause the filter basket to overflow.
• Make sure your coffee maker is clean. See "Care and Cleaning"
section.
8
For Carafe Side Only
Tabla de contenido
