Active TAGLIASIEPI Manual De Instrucciones página 53

If a torque wrench is not available, just extract the pin (2),
tighten the nut (1), maintaining a distance of 27 mm
between the inside of the intermediate jumper (4) and the
FIG . B
Periodically check that all of the machine's screws are in
their lodgings and are tightened properly. Replace any
damaged, worn or cracked parts. Check that the transmission
tube has been properly installed.
BEVEL GEAR Fig. 37 BEVEL GEAR Fig. 37 BEVEL GEAR Fig. 37 BEVEL GEAR Fig. 37 BEVEL GEAR Fig. 37
Every 50 working hours inject the bevel gear with gear grease
trough the hole (A).
Recommended grease: Special ACTIVE "NO MELT" Ref. Recommended grease: Special ACTIVE "NO MELT" Ref.
Recommended grease: Special ACTIVE "NO MELT" Ref. Recommended grease: Special ACTIVE "NO MELT" Ref. Recommended grease: Special ACTIVE "NO MELT" Ref.
21230. 21230. 21230. 21230. 21230.
Respect all of the previously described maintenance norms.
Clean the accessory carefully and grease the metallic parts.
Bush cutter: Empty the fuel tank and run the motor until the
residual fuel has been consumed. Store the machine in a dry
place.
TORQUE
WRENCH
TORQUE
LIMITER
REDUCER
FIG . A
extremity of the nut (1), and then replace the pin (2) in
such a way so that it catches in the slot (3) and not in the
thread. (See photos B - C)
BLOWER
For the maintenance of the motor, refer to the machine's
user and maintenance manual.
If in doubt, contact your nearest ACTIVE assistance
centre.
BRUSHCUTTER
BLADE BLADE BLADE BLADE BLADE
AIways check the general conditions of the blade.Replace
blade if craked,chipped or damaged in any way.
8. STORAGE
Remove the sparkplug, pour a small amount of oil into the
cylinder, use the starter to turn the motor shaft a few times
to distribute the oil and then reinstall the sparkplug.
Hedge trimmer accessory: Clean and lubricate the blades.
Check the amount of grease present within the reducers.
53
ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH
27 mm
2
1
4
GB
FIG . C
3