Active TAGLIASIEPI Manual De Instrucciones página 47

INSTALLING THE ACCESSORY TUBE - TILLER
ATTACHMENT
Loosen the black lever (7) located on the motor unit's hub
by turning it counter clockwise.
Insert the tube (4) into the motor unit's hub (8), lifting the
engagement pin initially (6).
Turn the blower right and left in alternation until the
engagement pin is heard to click into place.
Screw in the black lever (7) by turning it clockwise.
ASSEMBLY SAFETY GUARD Fig. 30 ASSEMBLY SAFETY GUARD Fig. 30 ASSEMBLY SAFETY GUARD Fig. 30 ASSEMBLY SAFETY GUARD Fig. 30 ASSEMBLY SAFETY GUARD Fig. 30
Mount the total protection (A + H) on the transmission
pipe (B) and secure using the jumper (C), screws (D),
piatrina (G) and nuts (F).
IMPORTANT: Make sure the jumper (C) is fixed to
the conical torque (L) through the screw and
washer (E). CAUTION: Use protection (A + H) with the
head of a nylon wire. Use only the protection (A) with the
lame.Per reasons of safety, the saw blades can not be
used with no protection provided.
BLADE ASSEMBLY Fig. 31-32 BLADE ASSEMBLY Fig. 31-32
BLADE ASSEMBLY Fig. 31-32 BLADE ASSEMBLY Fig. 31-32 BLADE ASSEMBLY Fig. 31-32
- Loosen the nut (1) clockwise; remove cup (2) (only if is the
skid unit version) and lower flange (3).
- Fit the blade (4) as showed in the picture making sure that
the upper flange (5) is well fitted.
- Fit the blade making sure that the rotation direction is correct
(the inscription on the blade should be facing up).
- Fit the lower flange (3), the cup (2) (only if is the skid unit
version) tighten the nut (1) anti-clockwise at 30 Nm (3.0 kgm).
- While tightening the nuts (1), the blade can be held fast by
inserting the allen key Ø 4 mm into the cap, the upper flange
and gear case holes. To do this, rotate the cutiing tool until
the two holes coincide.
NYLON HEAD ASSEMBLY Fig. 33-34 NYLON HEAD ASSEMBLY Fig. 33-34 NYLON HEAD ASSEMBLY Fig. 33-34 NYLON HEAD ASSEMBLY Fig. 33-34 NYLON HEAD ASSEMBLY Fig. 33-34
Mount the head of a nylon wire following the Illustrated:
upper flange (1) and turn clockwise to the head of nylon
threads.
BLOWER
BRUSHCUTTER
Tighten by hand clockwise head as shown in Fig.10 after
entering the Allen key (4 mm) in the conical bore of the
pair.
For your safety, use only original cutting tools.
FITTING THE ASSEMBLY FITTING THE ASSEMBLY FITTING THE ASSEMBLY FITTING THE ASSEMBLY FITTING THE ASSEMBLY
- Loose, counter-clockwise, the lever (1).
- Pull up the pin (12) and slip the tube (2) into the coupling (4)
as far as the reference (3) (about 40mm.). In order to ease
the introduction of the inner shaft (5) into the coupling shaft
(6), twisting slightly one way and the other the attachment
till it is slipped to the ref. (3).
Make sure that the pin (12) is inserted into the hole (13).
Block the tube through the lever (1)
at 30 Nm (3.0 kgm). at 30 Nm (3.0 kgm). at 30 Nm (3.0 kgm). at 30 Nm (3.0 kgm).
47
ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH GB