Active TAGLIASIEPI Manual De Instrucciones página 46

GB
ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH
INSTALLING THE ACCESSORY TUBE - TILLER
ATTACHMENT Fig. A
- Unscrew the 2 screws (2) and remove the plate (9)
- Loosen screw 1
- Insert the accessory tube, from the part upon which the tip
of the shaft is grooved (3), into the hole of the protective guard
(8) and then into the tiller unit (6)
- Tighten screw 1, making sure that it is aligned with hole 5 on
the transmission tube
- Mount the plate (9) and tighten the 2 screws (2)
- Only use the adaptor (7) between the accessory tube and the
plate (9), if you have a Ø 24 accessory tube.
If the installation has been completed successfully, the
tiller's two disks will turn when the transmission shaft is
turned manually.
FIG . A
INSTALLATION INSTRUCTIONS - Fig. 22 - 23 - 24 - 25 - 26
- Open the packaging;
- The supplied 3mm Allen Key is required in order to install
the olive shaker.
- Make sure that the 4 screws (13) of the "Y" shaped return
box (7) are loose (fig. 23)
- Insert the transmission tube (5) into the "Y" shaped return
box, starting from the part which has the yellow arrow label
(10) attached, keeping the holes (11) in a vertical position
(fig. 22)
Turn the tube clockwise and counter clockwise in alternation
until a click is heard; this means that the tube has been
properly engaged within the lodging.
Use the Allen Key to tighten the 4 screws (13 - fig.23)
Now we move on to the side where the Torque Limiter can
be found, which can also be identified by its close proximity
of the black rubber grip (6 - fig.24)
Loosen the locking ring nut (4) and repeat the simultaneous
engagement and rotation operations, keeping the tube
locking pin lifted at the same time (3 - fig.25)
TILLER
INSTALLING THE ACCESSORY TUBE - MOTOR TUBE
Fig. B
- Turn the lever (7) counter clockwise to unscrew it
- Lift the pin (6)
- Insert the tube (3) into the sleeve (8) down to its
reference point (2)
- Make sure that the pin (6) is aligned with the hole (3)
- Make sure that the attachment's transmission shaft (4)
is inserted into the motor's transmission shaft (5)
- Screw in the lever (7) by turning it clockwise
MOTOR
For the assembly and adjustment procedures relative to the
machine, see the specific user and maintenance manual for
the machine typology in your possession.
FIG . B
A40 OLIVE SHAKER
Again, it is necessary to continue with this movement until
the pin (3) engages with the appropriate hole (12) on the
tube (fig. 24), with a click.
Tighten the locking ring nut well, but only manually (4 - fig.
26)
Make sure that the flat areas are aligned on the tube's internal
shaft and on the integral joints of the torque Limiter and the
"Y" shaped return box (fig. 29)
CONNECTION TO THE VIPER or EVOLUTION MOTOR -
Fig. 27 - 28
Loosen the black lever (9) located on the motor unit's hub
by turning it counter clockwise (fig. 27)
Insert the tube (2) into the motor unit's hub, lifting the
engagement pin initially (3).
Turn the olive shaker right and left in alternation until the
engagement pin is heard to click into place (fig. 28)
Screw in the black lever by turning it clockwise.
.
46