Commissioning; Switch On/Off; Settings; Replacing Router Table - Festool MFK 700 EQ Manual De Instrucciones Original

[1-4] Router table for edge veneer with feel­
er roller and extraction hood (only in
SET scope of delivery)
[1-5] Handle, locking for routing depth
6

Commissioning

WARNING
Unauthorised voltage or frequency.
Risk of accidents
► The mains voltage and the frequency of the
power source must correspond to the
specifications on the name plate.
► In North America, only Festool machines
with the voltage specifications 120 V/60 Hz
may be used.
CAUTION
Heating of the Plug it connection if bayonet
fitting is not completely locked
Risk of burns
► Before switching on the power tool, make
sure that the bayonet fitting at the mains
cable is closed fully and locked.
Always switch off the machine before
connecting and disconnecting the mains
power cable.
Connecting and detaching the mains power ca­
ble - see Fig. [3].
6.1

Switch on/off

The switch [2-2] is an on/off switch (I = ON, 0 =
OFF).
7

Settings

WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
7.1 Electronics
The machine features full-wave phase control
electronics with the following features:
Smooth start-up
The electronically controlled smooth start-up
ensures that the machine starts up jolt-free.
Speed adjustment
You can regulate the speed steplessly between
10000 and 26000 rpm using the adjusting
wheel [2-1]. This enables you to optimise the
cutting speed to suit the material.
Constant speed
The motor speed remains constant through
electronic control to ensure a uniform cutting
speed even when under load.
Temperature control
To prevent overheating, the safety electronics
switches the machine off when it reaches a crit­
ical motor temperature. Let the machine cool
down for approx. 3–5 minutes before using it
again. The machine requires less time to cool
down if it is running, i.e. in neutral position.
7.2

Replacing router table

The large surface router table is already fitted
as standard. The large contact surface and pre­
cision adjustment features of this router table
enable a high degree of accuracy. Other router
tables are included in the accessories pro­
gramme.
a) Large surface router table
► Slide the router table onto the retaining pin
on the machine.
► Tighten the screw [4-1] to clamp the router
table in position.
► Place the extraction hood [4-2] in position.
► Tighten the screw [4-3] to clamp the ex­
traction hood in position.
► Place the extractor connector [4-4] on the
extraction hood.
Removal in reverse order.
b) Router table for edge veneer
The "router table for edge veneer" (only in SET
scope of delivery) is designed for flush trim­
ming veneer overhang and profile routing.
The router table is tilted 1.5° so that the
surface coating is not damaged during
edge routing. A router table with 0° incli­
nation angle for precise cuts is available
as an accessory.
► Secure the sensor [5-1] to the machine us­
ing the preassembled screws. Slide the
sensor in the long holes to adjust the rout­
ing tool to the perfect position.
► Slide the router table onto the retaining pin
on the machine.
► Tighten the screw [5-2] to clamp the router
table in position.
► Place the extraction hood [5-3] in position.
► Tighten the screw [5-4] to clamp the ex­
traction hood in position.
Removal in reverse order.
English
15