Troubleshooting; Self Diagnosis Display; Moisture Condensation; Problemas Y Soluciones - Samsung VP-D530 Manual De Instrucciones

Videocámara digital
Tabla de contenido
ENGLISH

Troubleshooting

Troubleshooting
Before contacting a Samsung authorized service centre, perform
the following simple checks.
They may save you the time and expense of an unnecessary call.

Self Diagnosis Display

Display
Informs that...
Blinking
the battery pack is almost discharged.
slow
When the remaining time
slow
TAPE END!
on the tape is about 2 minutes.
TAPE END!
no
the tape reached its end.
TAPE!
slow
there is no tape in camcorder.
slow
PROTECTION!
the tape is record protected.
slow
the camcorder has some mechanical
.... D
fault.
L
C
R
moisture condensation has formed in
slow
the camcorder.

Moisture Condensation

If the camcorder is brought directly from a cold place to a warm
place, moisture may condense inside the camcorder,
on the surface of the tape, or on the lens. In this condition, the
tape may stick to the head drum and be damaged or the unit
may not operate correctly.
To prevent possible damage under these circumstances, the
camcorder is fitted with a moisture sensor.
If there is moisture inside the camcorder,
displayed. If this happens, none of the functions except cassette
ejection will work.
Open the cassette compartment and remove the battery pack.
Leave the camcorder for at least two hours in a dry warm room.
104
104

Problemas y soluciones

Problemas y soluciones
Antes de ponerse en contacto con el centro de servicio haga las
siguientes comprobaciones. Es posible que le ahorren el tiempo y
el coste de una llamada innecesaria.
Pantalla de Autodiagnósticos
Action
Pantalla
Parpadeo
Change to a charged one.
Lento
Lento
TAPE END!
Prepare a new one.
No
TAPE END!
Change to a new one.
TAPE!
Lento
Insert a tape.
Lento
PROTECTION!
If you want to record,
release the protection.
....D
Lento
L
1. Eject the tape.
C
2. Set to OFF.
R
3. Detach the battery.
4. Reattach the battery.
* If unresolved contact your
local service representative.
Lento
see below.
Condensación de humedad
Si se lleva la videocámara directamente de un lugar frío a uno
cálido, se puede condensar humedad dentro de ella, en la
superficie de la cinta o en el objetivo. En estas condiciones la
cinta puede adherirse a los cabezales y estropearse o puede
que el aparato no funcione correctamente.
Si hay humedad dentro de la videocámara, aparecerá en la
pantalla la señal
(DEW) is
funciones de la videocámara operará, excepto la de expulsión
de la cinta.
Abra el compartimiento del casete y quite la batería.
Deje la videocámara durante al menos dos horas en un lugar
seco y templado.
ESPAÑOL
Indica que...
Solución
La batería está casi descargada.
Reemplácela por una cargada.
El tiempo restante de grabación
Prepare una cinta nueva.
es de unos 2 minutos.
La cinta ha llegado al final.
Cámbiela por una nueva.
No hay cinta en la videocámara.
Introduzca una cinta.
La cinta está protegida contra la
Si desea grabar, libere la
grabación.
protección.
La videocámara tiene algún fallo
1. Saque la cinta.
mecánico.
2. Apague la videocámara.
3. Quite la batería.
4. Ponga de nuevo la batería.
* Si no puede resolver el problema,
póngase en contacto con el
centro de servicio.
Se ha condensado humedad en
Ver más abajo.
la videocámara.
(DEW). Si esto sucede, ninguna de las
Tabla de contenido
loading

Tabla de contenido