Panasonic EY7441 Manual De Instrucciones página 14

Control Panel [Fig.11]
EN
(1) LED light [Fig.12]
Before the use of LED light, always pull
the power switch once.
Press the LED light button.
The light illuminates with very low current,
and it does not adversely affect the
performance of the tool during use or its
battery capacity.
CAUTION:
The built-in LED light is designed
to illuminate the small work area
temporarily.
Do not use it as a substitute for a
have enough brightness.
LED light turns off when the tool has
not been used for 5 minutes.
Caution: DO NOT STARE INTO BEAM.
Use of controls or adjustments or
performance of procedures other than
hazardous radiation exposure.
(2) Overheat warning lamp [Fig.13]
Indicates operation has been halted due to
motor or battery overheating.
To protect the motor or battery, be sure to
note the following when carrying out this
operation.
• If the motor or battery becomes hot, the
protection function will be activated and
the motor or battery will stop operating.
The overheat warning lamp on the
this feature is active.
• If the overheating protection feature
activates, allow the tool to cool
thoroughly (at least 30 minutes). The tool
is ready for use when the overheat
warning lamp goes out.
• Avoid using the tool in a way that causes
the overheating protection feature to
activate repeatedly.
EY971074418.indb 14
• If the tool is operated continuously under
high-load conditions or if it is used in
hot-temperature conditions (such as
during summer), the overheating
protection feature may activate
frequently.
• If the tool is used in cold-temperature
conditions (such as during winter) or if it
is frequently stopped during use, the
overheating protection feature may not
activate.
The performance of the EY9L42
10°C due to work conditions and other
factors.
(3) Battery low warning lamp
[Fig.14, 15]
Excessive (complete) discharging of
lithium ion batteries shortens their service
life dramatically. The driver includes a
battery protection feature designed to
prevent excessive discharging of the
battery pack.
The battery protection feature activates
immediately before the battery loses its
charge, causing the battery low warning
If you notice the battery low warning
immediately.
If it is started with too little battery power
remaining, the tool may stop operating
without the battery low warning lamp
too little battery power remaining to use
the tool, and the battery pack should be
charged before further use.
If the tool is subject to a sudden load
during use that causes the motor to
lock up, the overdischarge prevention
sensor may be triggered, and the battery
cause of the motor's locking up and cycle
the trigger.
The battery protection feature may
activate when a high load is abruptly
placed on the motor, even if ample
battery charge remains. In this case, both
the battery low warning lamp and LED
- 14 -
2018-05-28 10:27:02