Operation; Switching The Unit On/Off - Mitsubishi Electric PAR-SL100A-E Manual De Instrucciones

4. Operation

2
5
8
• The transmission mark
transmitted.
• The indoor unit beeps to confi rm that the signal transmit-
ted from the wireless remote controller has been received
by the receiver on the indoor unit. If the indoor unit does
not beep, transmit the signal again.

4.1. Switching the unit on/off

1. Press the
• The remote controller display turns on.
3
2. Press the
1
• Each time the button is pressed, the setting changes.
4
6
* If the automatic operation is selected, cooling operation
7
starts if the room temperature is higher than the set
temperature and heating operation starts if the room
temperature is lower than the set temperature.
If the AUTO (dual set point) mode is enabled,
played.
When setting the AUTO (dual set point) mode, you can
set 2 temperatures (1 temperature for cooling and 1
temperature for heating).
According to the room temperature, the indoor unit oper-
ates automatically in the cooling or heating mode to keep
the room temperature within the set range.
<Auto operation (dual set point) mode>
When the operation mode is set to the Auto (dual set point)
mode, two preset temperatures (one each for cooling and
heating) can be set. Depending on the room temperature,
indoor unit will automatically operate in either the Cool or
Heat mode and keep the room temperature within the pre-
set range.
The graph below shows the operation pattern of indoor unit
operated in the Auto (dual set point) mode.
Preset temp.
(COOL)
Preset temp.
(HEAT)
appears each time a signal is
button 1.
button 2.
Auto Heat Cool Dry
Operation pattern during Auto (dual set point) mode
The room temperature
changes corresponding
to the change in the
outside temperature.
HEAT COOL
Fan
is dis-
Room
temperature
HEAT COOL