Loop Handle Installation - Maruyama EH27D Manual Del Propietário

5. Adjust the cable adjuster sleeve so the stop on the carburetor throttle cam
just contacts the throttle stop and the cable position keep 1-2mm play
between cable lug and slotted fittings when the throttle trigger is fully
depressed.
6. When the throttle cable is adjusted correctly, tighten the lock-nut.
7. Plug the stop switch wires into the matching connectors from the engine.
Note that wire polarity is not important.

Loop Handle Installation

The loop handle kit contains a package of four screws and nuts, a rubber
sleeve (ONLY FOR EH27D) and the bottom clamp for the loop handle.
[EH27D]
1. Slip the rubber sleeve around the shaft approximately 9 inches (22.8
cm) from the end of the stop switch/throttle trigger assembly for an
initial handle position.
2. Rotate the rubber sleeve so the split is to one side.
3. Place the loop handle and the bottom clamp over the rubber sleeve.
4. Install the four screws and nuts. Leave the screws finger-tight.
5. Reposition the loop handle up or down the drive shaft to the most
comfortable position, but no closer than 9 inches (22.8 cm) from the
end of the stop switch.
6. Tighten the screws and nuts.
[EH27D-S]
1. Place the loop handle and the bottom clamp approximately 9 inches (22.8
cm) from the end of the stop switch/throttle trigger assembly for an initial
handle position.
2. Install the four screws and nuts. Leave the screws finger-tight.
3. Reposition the loop handle up or down the drive shaft to the most
comfortable position, but no closer than 9 inches (22.8 cm) from the end
of the stop switch.
4. Tighten the screws and nuts.
− US-13 −
1-2mm Play
Matching Connectors
Stop Switch Wires
Loop Handle
Screw (4)
Rubber Sleeve
Nut (4)
Bottom Clamp
[EH27D]
Loop Handle
Screw (4)
Nut (4)
Bottom Clamp
[EH27D-S]